Independent rider guide Last checked 18 Nov 2026
MX Handbook Get it on Steam

Controller, steering, and graphics settings

There is no studio default card. A Reddit thread and Kelso’s video agree on low linearity, FOV 120, and changing one setting at a time.

Rider screenshot beside the settings table
Corner screenshot beside the braking notes

The studio’s controls video shows where bindings live. It does not publish the gain and sensitivity numbers people paste into Reddit. Those numbers come from riders. I label each column with the person and the date, and I do not promote either column to “official defaults.”

Two cited presets, not a studio card
Gain1+12 sources
Sensitivity-2 to -4-42 sources
Linearity002 sources
Deadzone5 down toward 0 if the stick is clean52 sources
FOV1201202 sources
ABSAssists on while learningFront off, rear onSplit by source
Sit / standHold, not toggleNot the focus of that video1 source · Reddit

The Reddit megathread suggests starting on the 250F at Estrella and leaving assists on. Kelso, in the 70-hour settings video posted 14 Nov 2026, turns front ABS off, leaves rear ABS on, and uses a Steam Input chord so front and rear brake can share a control. He also says the menus he filmed were a pre-release build and could move. The November Discord note puts FOV under Settings, Camera, and unit choice under Settings, Interface.

Both the thread and Kelso’s video tell you to change one item, ride the same piece of track, then change the next. I agree with that method because the two presets already disagree on ABS. Copying five numbers at once makes it impossible to know which one helped. Deadzone in particular depends on a worn stick. A clean pad can go lower than 5. A drifting pad should stay higher. I am not printing a single deadzone as a law.

Graphics presets are thinner in the sources. The crash page has one report about FSR on an RX 9070 XT, plus a second rider with the same card who had no trouble. That is not a global “turn FSR off” preset, so it stays on the crash page. The studio has not published a low, medium, and high quality chart with frame targets.

Related studio videos from 16 Nov 2026 cover braking and body position. They are short. The beginner page turns those ideas into a first-hour plan. If the pad is not detected at all, you are on the wrong page: that is the controller fix page, including the lean-direction report.

Video

MTG Explained: Controls and Controller Setup

Questions

What are the best Motocross The Game settings?

There is no studio best. Reddit’s starter post and Kelso’s video both use gain around 1, linearity 0, and FOV 120. ABS differs.

Where is the FOV slider?

Riders point to Settings, Camera, after the November note that announced the slider.

Should I use a controller?

Steam says partial controller support and recommends a gamepad. It does not list supported models.

Sources

Checked 2026-11-18.

Changelog

2026-11-18: Reviewed public sources, source counts and page links for this edition.

Related

Beginner tipsWhat to practice before you chase a setup.Controller fixWhen the pad does not appear.Bikes250F versus 450F.